10 Foot Jon Boat For Sale Nyony

I drilled a hole in the middle of one for the fender bolt, peeled the Nitro Bass Boat Trailer Fenders Mod backing and put it place getting it as square with the fender edge as I could eyeball. I then placed Nitro Bass Boat Bass Boat Trailer Winch Stand For Trailer Fenders Mod one on either end. The adhesive sticks very well to the fender. I will keep an eye on it and if any come loose I will rivet them. The rubber looks good and should protect the boat from scratches and give and even better no slip step surface than the metal.

Another option: I saw a new Phoenix boat with similar fenders and diamond plate. This would help guide the boat and also provide something for the boat to land on if it should get above the fender. I considered raising the boards on my Nitro trailer, there are 5 screws that hold it in place, it would not be difficult.

I still might do that if this hack does not Nitro Bass Boat Trailer Fenders Mod work. Here are a couple pictures before and. It took me about 30 minutes to do both fenders. Metal Fender Top. Rubber Fender Top. What you describe is indeed a bit of an issue. I haven't had any major damage done but it is annoying at best. This is a good idea actually.

Also with those glued down water cannot get under the diamonplate cover. I'll add that Nitro Bass Boat Trailer Fenders Mod Nitro Bass Boat Trailer Fenders Mod I've been pretty impressed with the durability of the finish on the new trailers and lack of rust spots anywhere- mine is a so it's been in the water quite a bit now nitro bass boat trailer fenders mod very little rust showing.

Larry, When I did this mod my trailer had been out of the water for a couple days and about miles. There was water under the diamond plate! I think that Aluminum plate causes rust after a while? Zman, no doubt, fortunately the armor coating keeps the rust off unless it cracks or gets rubbed away. The Nitro Bass Boat Trailer Fenders Mod only area I've had to work on a Nitro Bass Boat Trailer Fenders Mod little is the joint where the tongue swings. I've had to sand and repaint some of the exposed ends at the joint and where it rubs in operation.

Larry Coots Member. Joined Apr 21, Messages 5 Reaction score 1 Location beckley wv. I have a z19 almost the same color scheme.

The first time I loaded it I damaged the bottom on the edge, then I had the same thing happen again last week loading in a strong wind storm. You can bet I will be doing. I'll share a tip that has worked for me on cosmetic repair nitro bass boat trailer fenders mod bottom chips that Nitro Bass Boat Trailer Fenders Mod aren't structural. Dry and clean chip or spots, mix Nitro Bass Boat Trailer Fenders Mod some JB Weld compound and work into the cracks or Boat Mod Trailer Fenders Bass Nitro chips.

Let it dry 24 hours then do any sanding Nitro Bass Boat Trailer Fenders Mod Nitro Bass Boat Trailer Fenders Mod necessary. The stuff will hold up permanently and can be almost invisible with a little paint or nail polish. Really and easy and inexpensive fix for chipped deep scrapes. Stuff happens and sure does hurt your feelings but sometimes it just don't need the expensive repair. You must log in or register to reply. Latest posts B. Introduce Yourself. Want Nitro Bass Boat Trailer Fenders Mod to Buy. Nitro Boats For Sale. Marine Electronics.

Latest: datbasstho Sunday at PM.

:) Great reporta hunter contingency conflict as well as take a shot only upon premonition. I unequivocally similar to a tableas well as dielectric douse. You'll stop when a vessel sinks.